|
|
Quadding
Machine
 |
Quadding Take Up
Suitable for Flange Dia 600/630 mm , Barrel Dia 300mm,
Traverse width 380 mm,Overall width 412 mm, bore Dia
40/80 mm,Bobbin Holding on Pintles, Reel Drive 5 H.P.A.C.
Motor, Variable Frequency Drive, Transmission Through
Timer Belt, Gear box ,Traverse mechanism U-Hinge with
adjustable Pitch 0-15 mm, Noise Proof cabnit, with inter
Locking by limit switch, loading/ unloading Plate /
Tackle, Preset Digital Length Counter, bow Motor 15
H.P.A.C., Variable Frequency Controlled for take up
Flyer Suitable for 3000 Twist/ Minute.
Spark Tester High Frequency
2.5 to 3.0 KHZ. At 0-10 Kv. Spark Taster stop the
Machine at every Running Fault. |
Lay Plate/ Quadding die
With Center Hole for Center PE String. Material
Stainless (Mirror Finish) with Ceramic Bushes
Air Conditioned Control Panel Provide Through PLC Txt
Display, Following Out Put
Pre Set Length Counter, Rpm/Tpm Meter, Speed Setting
pot. On Switch, Lay Change -Over Switch "
Left-Off-Right" Emergency off, Hour Counter,
Tension Preset Pots, Back Twist% - Presetting Pot. Three
Phase A.C. 415 Volt (+)/ (-) 10% 50 hz (+)/(-)2.0%
Electricity Supply Required.
|
|
|
